|Install an Automatic Blowdown Control System Background|
|Written by USDOE Office of Industrial Technologies|
|Thursday, 01 July 2010 07:49|
Install an Automatic Blowdown Control System Background
To reduce the levels of suspended and total dissolved solids in a boiler, water is periodically discharged or blown down. High dissolved solids concentrations can lead to foaming and carryover of boiler water into the steam. This could lead to water hammer, which may damage piping, steam traps, or process equipment. Surface blowdown removes dissolved solids that accumulate near the boiler liquid surface and is often a continuous process.
Suspended and dissolved solids can also form sludge. Sludge must be removed because it reduces the heat-transfer capabilities of the boiler, resulting in poor fuel- to-steam efficiency and possible pressure vessel damage. Sludge is removed by mud or bottom blowdown.
During the surface blowdown process, a controlled amount of boiler water containing high dissolved solids concentrations is discharged into the sewer. In addition to wasting water and chemicals, the blowdown process wastes heat energy, because the blowndown liquid is at the same temperature as the steam produced— approximately 366°F for 150-pounds-per-square-inch-gauge (psig) saturated steam— and blowdown heat recovery systems, if available, are not 100% efficient. (Waste heat may be recovered through the use of a blowdown heat exchanger or a flash tank in conjunction with a heat recovery system. For more information, see Steam Tip Sheet #10, Recover Heat from Boiler Blowdown.)
Advantages of Automatic Control Systems
An automatic blowdown-control system optimizes surface-blowdown rates by regulating the volume of water discharged from the boiler in relation to the concentration of dissolved solids present. Automatic surface-blowdown control systems maintain water chemistry within acceptable limits, while minimizing blowdown and reducing energy losses. Cost savings come from the significant reduction in the consumption, disposal, treatment, and heating of water.
How it Works
Conductivity is a measure of the electrical current carried by positive and negative ions when a voltage is applied across electrodes in a water sample. Conductivity increases when the dissolved ion concentrations increase.
The measured current is directly proportional to the specific conductivity of the fluid. Total dissolved solids, silica, chloride concentrations, and/or alkalinity contribute to conductivity measurements. These chemical species are reliable indicators of salts and other contaminants in the boiler water.
Price and Performance Example
Note: Based on continuous operation of a 150-psig, natural gas-fired steam boiler with fuel valued at $8.00 per million Btu ($8.00/MMBtu), a makeup water temperature of 60°F, and a boiler efficiency of 80%. Water, sewage, and chemical treatment costs are estimated at $0.004 per gallon.
Purchasing and installing an automatic blowdown-control system can cost from $2,500 to $6,000. The complete system consists of a low- or high-pressure conductivity probe, temperature compensation and signal conditioning equipment, and a blowdown-modulating valve. Some systems are designed to monitor both feedwater and blowdown conductivity from multiple boilers. A continuous conductivity recording capability might also be desired. The total cost of the automatic blowdown system is dependent upon the system operating pressure and the design and performance options specified.
FOR ADDITIONAL INFORMATION, PLEASE CONTACT:
EERE Information Center
Industrial Technologies Program
Energy Efficiency and Renewable Energy
U.S. Department of Energy
Washington, DC 20585-0121
|Saving Energy on Conveyor Belts
09/06/2010 | Western Area Power Administration
(original article available here) Technical help Case example July 2003 Question: What can be done to save energy on conveyor belt systems? One of our utility's customers operates outdoor conveyo [ ... ]
|Compressed Air Storage Strategies|
09/06/2010 | USDOE Office of Industrial Technologies
Compressed Air Storage Strategies